ONEchip (PM-41 (2)) Works fine but no stealth?

[Simon_G]

Using the diagrams for 8 pin installation and the ONEChip 8-Wire [PAL SCPH-102 ONLY].hex I can boot originals and backups from PAL / USA / JAP but cannot boot any ANTI-MOD games at all.

Its as if the stealth mode is not switched on as everything else works ok it would seem.

Any ideas?

Thanks in advance.

[Simon_G]

Tis ok, was me being stupid!

[Mamejay]

What chip did you burn the hex code to?

[Simon_G]

What chip did you burn the hex code to?

12F508. My programmer doesn't like the 12C series at all :( Need to invest in an el cheapo Willem I think.

[Bad_Ad84]

What programmer do you have?

Buying a Para willem is pointless. buy the GQ-4X, its USB and shit loads faster and not much more expensive

[Simon_G]

I have a few of them... a Genius G540 (which is shite by the way although pretty good for rescuing ATMega chips when I managed to screw the fuses up!) and a PICKit2 which I have been using to program the 12F series with pretty good results. I have been looking at the GQ-4X and it certainly looks the part. Will have to save a few pennies first though.

[APE]

I've had the GQ-4X for some time now and love it. Still need a few more adapters to handle more hardware but it works very well.

[Bad_Ad84]

I have a few of them... a Genius G540 (which is shite by the way although pretty good for rescuing ATMega chips when I managed to screw the fuses up!) and a PICKit2 which I have been using to program the 12F series with pretty good results. I have been looking at the GQ-4X and it certainly looks the part. Will have to save a few pennies first though.

I had a GQ-4X until I upgraded to the Elnec Beeprog+

Cant complain for the price

[Simon_G]

Cant complain for the price

800 or so Euros? It would have to make the tea too at that price :)

[Bad_Ad84]

"Cant complain for the price" was in reference to the GQ-4X, not the Beeprog+ :)

And yes, around that