Ripper IV on PS2 V10 installation!

[pago]

hi all!

I'm new here and hope this post is on the right side!

I'm trying to install RIpper IV modchip on my PS2 V10 board. My question is where are the alternative points located on board to be soldered? Can those M.N.O.P.Q...etc only be on the first side of the board?
And where are realy located the F,G,H,I,B1 points? Are these on the second side (the one with the heatsink) of the board?

Thnx! in Advance!
Pago

[mairsil]

Welcome to the boards, but you would be better off looking in the forums over at PS2-Scene.org for this kind of information.

[Golberg]

Yeah, this really isn't the best place for asking about modchips as we don't really deal with them here much. Welcome to the boards anyway.

[MikroLogika]

You can try to find alternate points using multimeter (conductivity checker).
Check other modchips diagramms for alternate points since many chips
use same points

[pago]

Ok! fellows!

Sorry about the posting here!:redface:

Regards!